ASME SECTION IX MCQs (Part-1)

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

ASME Section IX questions , Part-1 (10 Questions)
Every Question carry 1 Mark
Visit Website : WeldFabWorld.com for articles regarding ASME section IX

Email *

When a tensile specimen breaks in the base metal outside of the weld or fusion line, the strength recorded may be at most ____ below the specified tensile and be accepted.

1 point

3.5%

0.5%

All of the above

Clear selection

Charpy V-notch tests are performed to determine a weldment’s

1 point

Tensile strength

Ductility

Notch toughness

All of above

B and C both

Clear selection

A welder is qualified welding in 5G position is qualified for what position on plate ?

1 point

F, H, OH

F, V, OH

V, OH, SP

H, V, OH

Clear selection

The basic purpose of testing a welder is to establish the welder’s

1 point

Knowledge of welding requirements

Ability to deposit sound weld metal

Mechanical ability to operate equipment

General attitude toward welding inspectors

None of the above

Clear selection

The PQR must list:

1 point

Essential variables

Qualification test & examination results

Supplementary essential variables (when notch toughness is required)

All of the Above

None of the Above

Clear selection

What is the earliest Edition of Section IX recognized by the current edition?

1 point

1958

1992

1987

1962

None of the Above

Clear selection

A welder qualifying with a groove weld in plate in the 4G position is qualified to weld groove welds in plate and pipe over 24”O.D. in at least the

1 point

A. Vertical

Flat & horizontal

Flat & overhead

Horizontal

Clear selection

A welder qualifying by making a groove weld on pipe with an O.D. of 26.1 in the 5G position is qualified to weld groove welds in

1 point

25mm O.D. Pipe in the overhead position

21.3mm O.D. Pipe in the vertical position

168.3 O.D. pipe in the horizontal position

25mm O.D. Pipe in the horizontal position

All of the above

Clear selection

A welder qualifying with a groove weld welded from both sides is qualified to weld ________________

1 point

Without backing

With , Without Backing

With backing only

None of the Above

Clear selection

Guided-bend specimens shall have no open defects in the weld or heat effected zone exceeding __________ measured in any direction on the convex surface of the specimen after bending.

1 point

2mm

3mm

5mm

4mm

Clear selection

Send me a copy of my responses.

Submit

Clear form

reCAPTCHA

Privacy Terms

This content is neither created nor endorsed by Google. Report Abuse - Terms of Service - Privacy Policy

Forms