MODULE 11A- MOCK TEST 40 MARKS

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

www.amequestionpaper.in

Contact us for latest Module Question Paper (with answer) & Short Notes
+ 91 755 936 9412

Email *

The disadvantage of narrow channel spacing is

1 point

(a) the need for increased receiver sensitivity

(b) the possibility of adjacent channel interference

Clear selection

TACAN beacons transmit in the range

1 point

(a) 962 to 1213 MHz

(b) 1030 to 1090 MHz

Clear selection

A loop antenna is used for

1 point

(a) VOR and ADF,

(b) ADF and Omega

Clear selection

The Pressure sensing element used in Altimeter Instrument is:

1 point

a) Bourdon Tube

b) Evacuated Metal Capsule

c) U- Shaped Bracket

Clear selection

Input Supply for Strobe Light is

1 point

a) AC

b) DC

c) AC or DC

Clear selection

Above 30 Mhz which waves are utilized

1 point

a) Radio Waves

b) Sky Waves

c) Space Waves

Clear selection

Satellite Communication uses LEO satellites to

1 point

a) Provide greater Coverage

b) Maintain a geostationary position

c) Minimize Voice Delay

Clear selection

Nav Light Supply

1 point

a) 28V DC

b) 28V AC

c) 115V AC

d) Both a) and b)

Clear selection

The starboard wing tip navigation light has the following color and divergence

1 point

(a) red and 110 degrees

(b) green and 110 degrees

Clear selection

Master caution and warning lights are located on the

1 point

(a) lower instrument panel

(b) upper instrument panel

Clear selection

The frequency range of a VOR receiver is

1 point

(a) 108 to 117.95 MHz

(b) 108 to 1 1 1.95 MHz

Clear selection

Above 30 MHz propagation is by:

1 point

(a) space wave

(b) sky wave

Clear selection

The DFDR requires an electronic process such that

1 point

(a) Digitally coded data can be converted back(decoded) into its analogue form

(b) Digitally coded data can be converted back(encoded) into its analogue form

Clear selection

Fibre optics communication network uses

1 point

a) T Junction

b) Y Junction

c) Ring Topology

d) Both B & C

Clear selection

Do not Touch with Bare hands, will lead to premature failure of which type of light

1 point

a) Xenon

b) Fluorescent

c) Incandescence

Clear selection

Landing Lights are

1 point

a) Sealed beam devices

b) 600-1000W filament Lamps

c) Parabolic Reflector concentrates Light in a Directional Beam & Located on the wing tips or on the front of the fuselage

d) ATA

Clear selection

SATCOM uses

1 point

a) Geostationary Satellites

b) VHF

c) HF

Clear selection

What colour and shape of symbol is used for proximity traffic

1 point

(a) Solid red square

(b) Solid cyan diamond

Clear selection

TCAS II requires which type of ATC transponder

1 point

(a) Mode S

(b) Mode A

Clear selection

Moving MAP shown on IFE

1 point

a) Does not interfere with a/c Nav

b) Separate sensor avlb

c) Takes from a/c Nav sys

Clear selection

Engine RPM, Fuel flow indication shown on

1 point

a) PFD

b) Primary EICAS

c) Secondary EICAS

Clear selection

MTCS for TCAS

1 point

a) TCAS is an airborne system based on secondary radar

b) White Diamond, Red Square, Amber Circle

c) both

Clear selection

MTCS for BITE

1 point

a) Self-test feature built into airborne equipment as an integral fault indicator

b) a signal flow type test.

c) assist the avionics engineer with troubleshooting

d) ATA

Clear selection

A method used in modern aircraft for reporting in-flight faults to an engineering and monitoring ground station is

1 point

(a) TCAS II

(b) ACARS

Clear selection

ACARS is a digital data link system transmitted in the

1 point

(a) VHF range (129-137 Mhz)

(b) LF range

Clear selection

Attenuation in an optical fibre is due to

1 point

(a) absorption, dispersion, and radiation

(b) absorption, scattering, and radiation

Clear selection

Advantages of fibre optics :

1 point

a) Relative freedom from electromagnetic interference

b) Electrical isolation and freedom from earth/ground loops.

c) wide bandwidth and very high data rates can be supported &reduced noise and cross-talk compared with conventional copper cables

d) ATA

Clear selection

Which light cannot be tested by Ohmmeter?

1 point

a) Halogen

b) Xenon lamp

c) Incandescent

d) Fluorescent

Clear selection

MTCS for Current Limiter

1 point

a) Slow-Blow Fuse

b) Short delay before metal link melts & disconnect the circuit

c) Made of Copper with higher melting melting pt. than other fuses & Carry more than its rated Capacity & carry a heavy overlaod for a short time

d) ATA

Clear selection

MTCS regarding IMA

1 point

a) LRU is better than LRM

b) LRM is better than LRU

c) IMA uses LRU and used in rack

Clear selection

CDU provides a very powerful interface tool using:

1 point

a) Mode and Function Keys

b) Soft Keys

c) Alpha Numeric Keys

d) ATA

Clear selection

FMS outputs data to

1 point

a) EFIS Displays

b) Communication Management Units

c) Autopilot and Auto throttle

d) ATA

Clear selection

Cladding material in fibre optics has

1 point

a) Lower refractive index than the core

b) Higher refractive index than the core

c) Same refractive index than the core

Clear selection

The function of the squelch stage in an aircraft VHF radio is

1 point

(a) to eliminate noise when no signal is received

(b) to increase the sensitivity of the receiver for weak signals

Clear selection

In the HF band radio waves tend to propagate over long distances as

1 point

(a) ground waves

(b) space waves

Clear selection

Audio-video on demand (AVOD) entertainment enables passengers to

1 point

(a) pause, rewind, fast-forward or stop a programme

(b) make phone calls via satellite communication

Clear selection

The passenger address (PA) system is primarily a safety system that provides passengers with

1 point

(a) In-flight entertainment

(b) Reduced amount of IFE wiring to a seat position

Clear selection

MTCS Compass fluid used

1 point

a) Silicon Fluid to make the compass Aperiodic

b) It also provides Buoyancy, diminishing the effect of friction and wear.

c) Changes in Volume due temp. are compensated by bellows type expansion device, secured to the rear of the bowl.

d) ATA

Clear selection

SCR are also known as

1 point

a) Thermistor

b) Thyristor

c) Transistor

Clear selection

HF frequency is

1 point

a) 3-30 Mhz

b) 30-300 Mhz

c) 300-3000 Mhz

Clear selection

Submit

Clear form

This content is neither created nor endorsed by Google. Report Abuse - Terms of Service - Privacy Policy

Forms