CCNA Cisco Certified Network Associate Cisco 200-301 Part l

JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.

Email *

Write down your name. *

Write down your contact number. *

Q1: You are the network administrator for your company and have configured Cisco DiscoveryProtocol (CDP) in your network. You recently noticed that when devices send large numbers of CDP neighbor announcements, some devices are crashing. You decide to disable CDP on the router. Which command should you use to achieve the objective? *

1 point

no cdp run

set cdp disable

no cdp enable

no cdp advertise-v2

Q2: Which is NOT a valid range for private IP addresses? *

1 point

10.0.0.0 - 10.255.255.255

172.16.0.0 - 172.31.255.255

192.168.0.0 - 192.168.255.255

192.255.255.255-193.0.0.0

Q3: Which of the following protocols allow the root switch location to be optimized per VLAN? (Chooseall that apply.) *

1 point

PVST+

RSTP

PVRST

STP

Required

Q4: Your assistant just finished configuring a small test network as part of his training. The network is configured as shown in the diagram below: *

1 point

The IP address of Host A and the IP address of the Fa0/0 interface of Router A

The IP address of the Fa0/0 interface of Router A and the IP address of the Fa0/0 interface of Router B

The IP address of Host A and the IP address of the Fa0/0 interface of Router B

The IP address of Host A and the IP address of Switch A

The IP address of the S 0/0 interface of Router A and the IP address of the S 0/0 interface of Router B

The IP address of Host A and the IP address of Host B

The IP address of Host B and the IP address of the Fa0/0 interface of Router B

Q5: Which two fields are present in the output of the show ip interface brief command? (Choose two.) *

1 point

YES?

Helper address

OK?

Method

Proxy ARP

Required

Q6: Which two modes are the Cisco Internetwork Operating System (IOS) operating modes? (Choose two.) *

1 point

User Privileged mode

User EXEC mode

Local configuration mode

Global configuration mode

NVRAM monitor mode

Required

Q7: Which of the following accurately describes the purpose of a trunk? *

1 point

A trunk is used to carry traffic for a single VLAN and is typically used between switches.

A trunk is used to carry traffic for a single VLAN and is typically used between a switch and an end-user device.

A trunk is used to carry multiple VLANs and is typically used between switches.

A trunk is used to carry multiple VLANs and is typically used between a switch and a server.

Q8: Which Ethernet LAN contention or access method listens for a signal on the channel before transmitting data, and stops transmitting if a collision is detected? *

1 point

CSMA/CA

CSMA/CD

CSMA/CB

CSMA/CS

Q9: *

1 point

EIGRP will be enabled in AS 44

EIGRP instance number 44 will be enabled

EIGRP will be activated on the router interface 10.0.0.2/8

EIGRP will be activated on the router interface 192.168.5.9/24

EIGRP will be activated on the router interface 10.0.5.8/16

EIGRP will be activated on the router interface 192.168.6.1/24

Required

Q10: *

1 point

Configure a bandwidth on the serial interface.

Perform a no shutdown command on the serial interface.

Configure a private IP address on the Fastethernet0/0 LAN interface.

Change the IP address on the serial interface.

Clear form

Never submit passwords through Google Forms.

This content is neither created nor endorsed by Google. Report Abuse - Terms of Service - Privacy Policy

Forms