JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.
ASME SECTION IX MCQs (Part-2)
ASME Section IX questions , Part-2 (10 Questions)
Every Question carry 1 Mark
Visit Website : WeldFabWorld.com for articles regarding ASME section IX
* Indicates required question
Email
*
Your email
When using radiographs to qualify welder, the acceptance standards used are found in
1 point
ASME Section V
ASME Section IX
C. ASME Section VIII
B31.1/B31.3
Clear selection
Immediate retests of welders’ qualifications coupons:
1 point
Must use the same method
May use any method
Are not allowed
Require Inspector approval
Clear selection
Which of the following welding processes are currently not permitted to be used with SWPs as referenced in Appendix E of ASME IX?
1 point
GMAW
SAW
PAW
All of the above
Clear selection
Groove weld test may be used for qualification of welders. Which of the following shall be used for evaluation if welding process is SMAW?
1 point
Only bend tests
Only radiography
Both radiography and bend tests
Either bend tests or radiography
None of the above
Clear selection
Reduced-section tensile test specimens conforming to QW-462.1 (b) may be used on all thicknesses of pipe having an outside diameter greater than:
1 point
2 inches
2 .5 inches
3 inches
3.5 Inches
4 Inches
Clear selection
A welder qualified for SMAW using an E7018 electrode is also qualified to weld with:
1 point
E7015
E6011
E6010
E7024
All of the Above
Clear selection
What period of inactivity from a given welding process requires the welder to re-qualify in that process?
1 point
More than 3 months
More than 6 months
More than 4 months
More than 12 months
As stated by the AI
Clear selection
A welder qualified to weld in the 2G position on pipe would have to be qualified in which of the additional positions to qualify for all position groove welding on pipe?
1 point
1G
2G
5G
4G
All of the above
Clear selection
Tension tests may be used in lieu of bend tests to qualify welders or welding operators.
1 point
True
False
Clear selection
A non-essential variable may be changes without re-qualification because:
1 point
Nobody cares about non-essential variables
The welder is allowed to change variables at his discretion
Non-essential variables do not affect the mechanical or notch-toughness properties
Non-essential variables cannot be changes without re-qualification
Clear selection
Send me a copy of my responses.
Submit
Page 1 of 1
Clear form
reCAPTCHA
Privacy
Terms
This content is neither created nor endorsed by Google.
Report Abuse
-
Terms of Service
-
Privacy Policy
Forms