JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.
Cold Saw CS 350 Quiz
Sign in to Google
to save your progress.
Learn more
* Indicates required question
Email
*
Your email
First Name
*
Your answer
Last Name
*
Your answer
What machine checks should be done before cutting
*
1 point
Blade is mounted correctly and has no chipped teeth
coolant is not flowing on to the floor
Guard is free to open
Vise is set to desired angle
there is oil in the oil check window
Required
When making a cut how should you proceed
*
1 point
you have identified the material and it is ok to cut on this machine
area is cleared of debris
material is clamped securely
material is properly supported on each end
blade is brought down slowly and cut is made with little downward pressure
Required
what material can you cut ?
1 point
square and round tube
12" X 12" plate
18 gauge material
stainless steel rod
truck springs
hex rod
what extra precautions should you take to cut round profiles?
1 point
tighten the vise extra tight
use the v block
raise the materil up slightly
use vise-grips to keep from spinning
Clear selection
what is the shortest section you can cut ?
1 point
1/2"
3/4"
5/16"
1"
Clear selection
How do we identify the materials we can cut on the cold saw
*
1 point
look for rust
look for manufacturers markings and check online
file, magnet, surface appearance and spark test
perform a Rockwell hardness test
Why can't we cut hard alloys on this machine
*
1 point
too dangerous
Hard alloys dull the blade very quickly
frame is too light
too many sparks
Required
What safety equipment is required
*
1 point
ear protection
face shield
gloves
natural fiber clothing
glasses
well fitting clothing with no loose items
Required
what materials can you cut with the cold saw
*
1 point
copper
titanium
mild steel
stainless steel
tools steel
aluminum
wood
plastic
Required
If the saw binds and stalls you should ______
*
1 point
lighten the force
turnoff saw and back out
increase the coolant flow
it runs so slow it doesn't matter
How do you cut irregular material that you can not secure in the vice
*
1 point
tighten vice extra hard
weld it to the vice and cut off after
do not cut
use extra clamps
how should you position material when cutting long pieces
*
1 point
doesn't matter, just clamp firmly
With anything over 3 feet supported
lay it along shelf to the right
move saw to middle of the floor for maximum roon
Would you use an cold saw to cut a 1" solid block of steel ?
*
1 point
Yes
No
Would you use a cold saw to cut sheet metal
*
1 point
Yes
No
what safety checks should you perform when approaching the machine for your first cut
*
1 point
check Machine is safe and ready to use
there is enough air flow
you are wearing proper safety gear
Nothing loose e.g. hair, jewelry, shirt etc
no debris or oil to step on
blade has no missing or chipped teeth
Required
Submit
Clear form
Never submit passwords through Google Forms.
This form was created inside of The Curious Forge.
Report Abuse
Forms
