JavaScript isn't enabled in your browser, so this file can't be opened. Enable and reload.
ASME SECTION VIII DIV. 1 QUIZ-PART-1
ASME Section VIII DIV. 1 questions , Part-1 (10 Questions)
Every Question carry 1 Mark
Visit Website : WeldFabWorld.com for articles/Quiz regarding ASME Codes
* Indicates required question
Email
*
Your email
Name
*
Your answer
Which of the following is a category "D" welded joint in a pressure vessel
1 point
Welding joint connecting a flange to main shell
Longitudinal joint within the main shell
Circumferential joint within the main shell
Welded joint connecting a nozzle to main shell
Clear selection
Two plates with different thickness of 20 mm and 14 mm are to be welded to connect shell of pressure vessel. How much minimum taper transition is required
1 point
18 mm
12 mm
24 mm
30 mm
Clear selection
What is the minimum required thickness of a pressure vessel name plate
1 point
Shall be sufficient to resist distortion due to the application of the marking
>0.100 inch
>0.020 inch
>0.030 inch
Clear selection
The mill under tolerance for a plate of 1/2” thickness in Section VIII Div.1 is
1 point
0.3 mm
0.75 mm
1 mm
6% of the thickness
Clear selection
For a cylindrical shell that was designed for internal pressure the tolerance for out-of-roundness must be maintained and is based on the difference of the maximum and minimum inside diameters. This tolerance is;
1 point
It shall not exceed 10%
It shall not exceed 1.5%
It shall not exceed 1%
It shall not exceed 0.10%
Clear selection
Which of the following describes a Standard Hydrostatic Test
1 point
Test to be conducted at the calculated MAWP of the vessel.
Test to be conducted at the calculated MAWP of the vessel multiplied by 1.5
Test to be conducted at the calculated MAWP of the vessel multiplied by 1.1
Test to be conducted at the calculated MAWP of the vessel multiplied by 1.3
Clear selection
A linear indication when using magnetic particle testing is described as one
1 point
having a width greater than two times the length.
having a length greater than four times the width.
having a length greater than three times the width.
having a width greater than three times the length.
Clear selection
What is the maximum permitted temperature of a PWHT furnace at the time a pressure vessel is place in it
1 point
205 Deg. C
250 Deg. C
425 Deg. C
350 Deg. C
Clear selection
What will the joint category for shell connecting to hemispherical dish end
1 point
Category-A
Category-D
Category-C
Category-B
Clear selection
What is the depth of the notch for a charpy impact specimen
1 point
2. 5 mm
10 mm
2 mm
3 mm
Clear selection
Send me a copy of my responses.
Submit
Page 1 of 1
Clear form
Never submit passwords through Google Forms.
reCAPTCHA
Privacy
Terms
This content is neither created nor endorsed by Google.
Report Abuse
-
Terms of Service
-
Privacy Policy
Forms